Post by alanwalker on Dec 9, 2017 4:54:57 GMT -5
Hii...
Just purchased the above yoke and noticed there was an issue with the dead zones - did a search and seems to be loads of mods to fix it (including using bands) - but also seems to be a driver update that fixes it see below: posts:
Can any users confirm if this update solves the issue?
If yes what is the correct way to set up the yoke after the update can see there are 3 ways to configure the yoke (bit confused about what settings I should be selecting - so any help appreciated options seem to be:
In the XP11 setup menu there seems to be a sensitivity and other options for the yoke?
In the windows game controller menu there seem to be a dead-zone configuration for x and y zone - seems to be three tags and you can drag the 2 outliers into the centre so all tags are clustered together in the center?
Thanks..!
I didn't find the right solution from the Internet.
References:-
forums.x-plane.org/index.php?/forums/topic/135131-saitek-pro-yoke-deadzone-problem/
2D Animation Explainer video
Just purchased the above yoke and noticed there was an issue with the dead zones - did a search and seems to be loads of mods to fix it (including using bands) - but also seems to be a driver update that fixes it see below: posts:
Can any users confirm if this update solves the issue?
If yes what is the correct way to set up the yoke after the update can see there are 3 ways to configure the yoke (bit confused about what settings I should be selecting - so any help appreciated options seem to be:
In the XP11 setup menu there seems to be a sensitivity and other options for the yoke?
In the windows game controller menu there seem to be a dead-zone configuration for x and y zone - seems to be three tags and you can drag the 2 outliers into the centre so all tags are clustered together in the center?
Thanks..!
I didn't find the right solution from the Internet.
References:-
forums.x-plane.org/index.php?/forums/topic/135131-saitek-pro-yoke-deadzone-problem/
2D Animation Explainer video